ADVANCED MANUAL / Bit One /
47
If, when launching the Bit One PC software the following
Warning window appears, you can choose between the
following two ways to proceed:
A - Use a previous version of the PC software. Example: if
you are using the PC software v. 1.5, open the v.1.3;
B - Update the Bit One Firmware.
In this second case you will have to proceed as
follows:
- Save the previously set setup (in case you want to
open it in OFF LINE mode);
- Press OK on the Warning window;
- Restart the Bit One PC software and select the
RESCUE MODE;
10. TROUBLESHOOTING
10.3 RESCUE MODE
10.2 BACKGROUND NOISE
10.1 SYNCHRONIZATION WITH THE PC
1. The first screen will show the Firmware version currently
installed in the Bit One providing the ability to access to the
menu / the update functions;
Loud whistle /background hiss
In case a loud whistle / background hiss can be heard, it may be necessary to repeat the input sensitivity auto-setup
and / or to rectify the output levels adjustment.
For more information, see sections 8.4.2, 8.5.2 and 9.11 in this Manual.
- If, while tuning the system with a laptop PC connected to the Bit One, the device shows some functioning
problems, try to disconnect the laptop PC power supply cable. This way, with the laptop PC working on battery
power, you avoid a possible voltage difference in USB ground connection between car ground (Bit One) and
earth (PC).
1. Bit One functioning problems
- If, while tuning the system with the PC connected to the Bit One, the device does not respond, proceed as per the
following steps:
a- turn the Bit One off:
- pushing the DRC knob, or
- disconnecting the Remote IN, or
- disconnecting the power supply cable for few seconds;
b- save the setup as a file on the PC using the function: FILE / SAVE SETUP;
c- exit the software;
d- turn on the Bit One;
e- launch the software again;
f- load again the setup file using the function: FILE / LOAD SETUP.
3. Bit One does not respond
2. Bit One does not connect to PC software
- If, while tuning the system with the PC connect to the Bit One, the device is switched off and then on again, the
connection is lost and the software can not “finalize” the selected setup. If you don’t want to lose the
modifications and setup previously selected, proceed as per the following steps:
a- save the setup as a file on the PC using the function: FILE / SAVE SETUP;
b- exit the software;
c- turn on the Bit One;
d- launch the software again;
e- load again the setup file using the function: FILE / LOAD SETUP.
4. Settings not stored
- In order to successfully complete the Bit One set up phase and not to lose the work done, remember to store
the selected settings. Select “File” from the management software menu via the PC and then choose “Finalize
to Bit One”.
10
To Next Page
Loading...
