ADVANCED MANUAL / Bit One /
50
11.
At this point you have to reset the settings, by
selecting the “Restore Factory Defaults” entry from the
“File” menu
(see section 9.2.8).
12.
A Warning window will show up asking confirmation
about resetting the settings. Click “YES”.
13.
Exit the program, by clicking on CANCEL;
then turn the Bit One off.
14.
Turn the Bit One on. Launch the Bit One PC Software
v. 1.5 and proceed clicking on “Next”, following the
standard setup and inputs/outputs setting procedure
(see section 8).
15.
If necessary, manually reload the settings of filters,
delays and equalizations that you previously wrote down,
or load again the previously saved setup through the Load
Setup function.
10
To Next Page
Loading...
