ADVANCED MANUAL / Bit One /
49
WARNING: to secure the Firmware updating procedure, disconnect, if any, the PHONE terminal block from the Bit
One plugs.
The firmware update procedure requires particular attention. So, it must be performed under the best possible
conditions: if the firmware update is launched but prematurely interrupted (for example, because the PC locks
up or the USB accidentally disconnects during the update), you need to contact our Customer Service for further
support as the DRC memory reprogramming may be necessary.
REMARK: If the DRC Firmware is not displayed or if an
older version than v. 1.50 is displayed, we recommend
that you update the DRC Firmware.
7.
Before starting the Bit One update, the software will offer
the following warnings:
- do not disconnect “bit one” device, unplug power or
terminate this application during updating process;
- disable standby and energy saving features;
- close all running applications;
- disable anti-virus and anti-spyware systems.
10.
Launch the PC software still in RESCUE MODE.
If the firmware update has been correctly completed, the
dialog box will show the following indications:
- new Bit One Firmware version (v. 1.5.0.0);
- new DRC Firmware version (v. 1.50).
8.
Once you have clicked “OK”, the Bit One Firmware update
starts. The updating process will last from 3 to 5 minutes
and the green progressing bar will prove the update correct
processing.
9.
Once the update has been successfully completed the
window you can see on your right will appear. To use the Bit
One again, you have to exit the software through the PC,
turn the Bit One off and start it all again.
WARNING:
if during the updating process the
progressing bar stops for few seconds, it is normal. Do
not interrupt the process in any way.
10
To Next Page
Loading...
