Audison bit one - Dynamic Equalization Wizard (Advanced Mode)

ADVANCED MANUAL / Bit One /
45
The semi-automatic procedure
continues requesting to set the
reference listening volume level to high.
Set the Volume cursor adjusting it at the
desired level.
Once you have adjusted the cursor,
press the START button.
Move the EQ cursor to tune the
equalization of the high volume
response until you get the desired
sound.
Once you have found the right
adjustment press the SAVE button.
Now the reference curve for a high
volume listening level has been entered.
2. ADVANCED MODE
In this mode the equalization curve is
not fixed but it can be selected through
a 31-band graphic equalizer.
The steps to adjust it are exactly the
same as those described so far, adding
to them the possibility of operating with
a custom curve.
Just for example on your right you can
see the main screenshot showing a
“custom” equalization.
To confirm the adjustments and enable the
Dynamic Equalizer while listening to the music
click on the X
(Fig.9).
After enabling the “Dynamic Equalization”,
the “Dynamic Equalization ON/OFF”
provides the ability to turn on (ON) or off
(OFF) the acoustic effect of the equalization
while listening to music
(Fig.10).
The “Dynamic Equalization ON/OFF”, useful
while adjusting the system through the PC, is
also available on the DRC
(see section 12.2).
To confirm the adjustments and enable the
Dynamic Equalizer while listening to the music
click on the X
(Fig.9).
After enabling the “Dynamic Equalization”,
the “Dynamic Equalization ON/OFF”
provides the ability to turn on (ON) or off
(OFF) the acoustic effect of the equalization
while listening to music
(Fig.10).
The “Dynamic Equalization ON/OFF”, useful
while adjusting the system through the PC, is
also available on the DRC
(see section 12.2).
Fig.6
Fig.7
Fig.8
Fig.9
Fig.10
Fig.11
9