EasyManua.ls Logo

Audison LR 604 - Audison Amplifier Key Features; Important Precautions for Amplifier Installation; Critical Warnings for Amplifier Usage

Audison LR 604
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
34
FEATURES
LR 604 - LR 604 XR: Four-channel amplifiers with compact dimensions and
excellent musical performances.
The outstanding features of their sophisticated circuitry are: "FRONT END"
stages realized by two complementary differential stages, final stages made of
transistors in Darlington connection, final transistors with in current capacity of
15 A and MOSFET PWM power supply with high energy reserve.
LR 604: Four channels, single or double input. It can work with 4, 3, and 2
channels.
LR 604 XR: Four channels, single or double input, electronic crossover with
linear adjustment which can also be excluded, HI-PASS / BY-PASS output. It can
work with 4, 3, and 2 channels (crossover off) or with 2 channels for HI-PASS and
SUB stereo / mono (crossover on).
PRECAUTIONS
·In order for this device to function properly it's important that it is installed in a
spot where temperature doesn't fall below 0°C (32°F) or rise above 55°C (131°F).
· It must be installed in a dry and well ventilated spot.
· Power supply voltage is 12 VCC with negative to ground. Make sure that the
characteristics of the vehicle electrical system are compatible with this device.
· For safe driving we advise to listen to music at a volume level that won't drown
external traffic sounds.
INSTALLATION
For mounting use 4 self-threading screws and protective plastic rings provided.
For a very good result we suggest to use audison cable products to complete your
installation. These include: power cables, signal cables, speaker wires, RCA
connectors and all accessories needed to complete the wiring.
WARNINGS
· INPUTS: If the radio-cassette player doesn't share the output GND with the
chassis, the braided shield of the shielded cable must be connected to the radio-
cassette player chassis.
· OUTPUTS: Never connect -R and -L outputs to ground or to each other. If a
crossover filter is used, be sure its two channels don't have a common ground.
· REGULATIONS: If you hear saturation phenomena at moderate volume levels,
it means that a distorted signal is coming from the radio-cassette player. Turn
radio-cassette player volume down until there's no longer any distortion.
Then adjust the amplifier calibration levels until you hear slight saturation
phenomena.
ENGLISH
LR 604 XR (CROSSOVER ON)
ONE INPUT / SUB MONO
LR 604 XR - (CROSSOVER ON)
WIDEBAND FRONT AND REAR WITH OR WITHOUT FADER

Related product manuals