- To disable the Multipoint function on the EP616:
1. Turn off the EP616 and all source devices.
2. Press and hold the Power button for 5 seconds to turn on
the EP616 and put it into pairing mode. In pairing mode the
status LED will flash red and blue.
3. Double press the power button to disable the multipoint.
6 Charging.
Connect the EP616 to a powered USB port using the provided
USB charging cable. While charging, the status LED will light
red. It will turn blue once the battery is fully charged.
A full charge takes approximatively 1.5 hours depending on
power input.
Note:
1) Ensure that the output voltage from the USB port or the
charger is 5V. Charging voltage greater than 5V may
damage the headphones.
2) Please fully charge the EP616 before first use or if left
unused for a long period of time.
If you are using a smart USB charger, use the common USB
port and ensure that the output voltage is 5V.
7. Specification
Bluetooth Version v4.1 with aptX
Bluetooth Distance 10m
Transmission Frequency 2.40GHz-2.48GHz
Support Profile HSP/HFP/A2DP/AVRCP
Speaker Diameter Ø6mm
Impedance 16Ω
Sensitivity 86+/- 3dB
Speaker Output 3mW x 2
Frequency Response 120Hz-20KHz
Signal and Noise Ratio(SNR) ≥80dB
Distortion ≤3%
Battery Type 3.7V/110mAh Built-in Li-Polyme Battery
Charging Time 1.5Hours
Continuous working time 7 hours
Standby Time 18days
Dimensions 550 × 26× 12mm
Net Weight 10g
- 8 -
- 7 -
English
To Next Page
Loading...
