August MB300 - Power Supply; Specifications; Frequently Asked Questions

10. Specifications
2.4 inch(6.1 cm)
LCD Display
2 x 3 Watts with diameter 50mm
Speakers
Radio
.mp3 format
Music Player
Rock, Normal, Jazz, Pop and Classic
MP3 Equalizer
800 mAh Lithium-ion rechargeable
Built-in Battery
2 x AAA batteries
Clock Backup Power
5V
Power Adaptor
87.5 – 108 mHz
130 (W) x 90 (H) x 95(D) mmDimensions
500g (525g with 2 x AAA batteries)Weight
Support SD/MMC card up to 32GB
Card Reader
Support USB memory stick in FAT format
and up to 8GB
USB Port
9. Power Supply
This device can be powered by the supplied external AC
adaptor, USB cable and built-in Lithium rechargeable
battery.
When an external power supply is connected, it will
automatically charge the Lithium battery.
The internal battery takes approximately 3 hours to fully
charge.
The LED on the top of the device will NOT turn off when
the battery is fully charged.
Power supply to the clock is backed up by 2xAAA batteries.
These ensure that the time does not reset when the internal
battery runs out.
-10-
11. Frequently Asked Questions
The problems listed below do not necessarily signify a fault with
the device. Please check this list before requesting repairs.
-11-
Problem
Possible Cause
No power
Power adaptor plug loose/
faulty or Lithium battery
flat.
No radio Signal shield or internal
battery flat
Music player not
playing
Music file(s) format not
compatible or internal
battery flat
The memory card/
USB stick with
music but says no
song
Battery cannot be
charged or does
not last long
Remote control
not working
Music file(s) format not
compatible or memory
card/ USB stick faulty
The internal battery is
too old and needs to be
changed
Battery too low
Solution
Check power adaptor plug.
Convert music file(s) to .mp3
format or plug the AC power
adaptor on
Convert music file(s) to .mp3
format or try different memory
card/ USB stick
To get battery changed by an
authorised professional
service provider
Change remote control battery
Try different locations or plug
the AC power adaptor on
1.This operation instruction is only intended for reference.
No further notice is available to any modification of all
information contained therein. Due to continuing
improvements, the features and design are subject to
change without notice.
2. No user serviceable components are fitted inside this device.
Do not attempt any repairs, as this will invalidate the warranty.
Any repairs must be carried out by either the manufacturer or
their nominated service centre. Parts inside this device are
subject to high voltage.
Warning