August MR270 - Connecting a Device; Clearing Bluetooth Connections; Charging and Power Saving; Charging the Device

-4-
-5-
English
7. Specifications
Bluetooth Version v4.1 aptX Low Latency
Bluetooth Profile
Operating Range
Power Input
Internal Battery
Working Time
Charging Time
A2DP, AVRCP, PBAP
Up to 10m
DC 5V/300mA
400mAh Li-polymer Battery
Approx 15 hours
Approx 1.5 hours
Dimensions
Net Weight
52x40x18mm
30g
5.2.1 Connecting a Device
1. Press button I or II to enter pairing mode. In
pairing mode the status LED will flash white
and blue alternately.
2. Enable Bluetooth on the receiving device and
enter pairing mode (see the device's user
manual for more information).
3. The MR270 will connect automatically to the
receiving device.
Once successfully paired, status LED I or II will
light blue constantly.
5.2.2 Clearing Bluetooth Connections
Press and hold button II for 5 seconds to clear all
paired devices from the MR270.
6. Charging and Power Saving
6.1 Charging the Device
The status LEDs will flash white when the battery
is low. To recharge, connect the MR270 to a
power USB port using the provided USB power
cable.
Whilst charging, the charging LED will light red
and turn green once the battery is fully charged.
A full charge takes approximatively 1.5 hours
depending on power input.
Note: When powered by a USB cable the MR270
will switch on automatically.
6.2 Power Saving
When the transmitter is switched on and powered
by the battery, but no Bluetooth connection is
available, or no devices are connected, the
MR270 will switch off automatically after 30
minutes.