Aukey KM-G16 - Getting Started; Editing Custom Lighting Effects; Recording Macros

Getting Started
Editing the Custom Lighting Effects
Notes
Plug the USB connector of this keyboard into a USB port on your computer
or laptop
Press “Fn + PrtSc” repeatedly to select one of the 14 lighting effects
Press “Fn + ↑” to increase the brightness, or “Fn + ↓” to decrease the
brightness
Press “Fn + →” to increase the lighting effect speed, or “Fn + ←” to decrease
the lighting effect speed
1.
2.
3.
4.
Press “Fn + 1, 2, 3, 4, 5, or 6” (Fn key with a main number key from 1 to 6)
to select one of the six custom lighting effect slots
Press “Fn + ScrLk” to start editing. The 4 LED indicators at the top-right of
the keyboard will flash rapidly
Turn lighting on or off for any key by pressing the key. Then save the
custom lighting effect by pressing “Fn + ScrLk”
1.
2.
3.
Recording Macros
Press and hold “Fn + Pause” (Fn key with the key above “PgUp”) for 5
seconds to enter the macro recording mode
1.
The color of the keys can’t be changed
•
- 04 -