- 03 -
Power On / Off
● Press and hold the on/off button for 2 seconds to power on or off (LED indicator
blue or off)
Pairing
1. When you turn on the speaker, the speaker will automatically enter pairing
mode and the LED indicator will start to flash blue rapidly
2. Activate the pairing function on your phone or other compatible device and
select “AUKEY SK-S1”
3. If a code or pin is required for pairing, please enter “0000”
4. When successfully paired, the LED indicator will stay blue
Notes
● To reset the speaker (to clear the pairing list or any program errors), use a
straightened paper clip or a toothpick to carefully short-press the reset button
(furthest inside the 3.5mm audio input jack)
● The speaker will automatically shut down after 10 minutes in pairing mode
if no devices are paired
● If your paired device is switched off or manually disconnected, the speaker
will enter pairing mode and automatically shut down after 10 minutes
● If the speaker or connected device exceeds the operating range, the speaker
will disconnect. The connection to the last successfully connected device
will be re-established once you re-enter wireless range within 10 minutes. To
connect to other devices, please repeat the previous “Pairing” steps
Playing Audio via Audio Input Connection
1. Connect the SK-S1 to your PC, laptop, or other device with audio output
port using the included 3.5mm audio cable
2. Press and hold the on/off button for 2 seconds to turn on, and the LED indicator
will light up solid green
Notes
● The speaker will disconnect from your phone or other paired device when
an audio cable is plugged into the audio input jack
● When playing audio using the audio input jack, press the volume + / - to adjust
the volume and short-press play/pause to pause or resume. Next/previous
track control on the speaker is disabled in audio input mode
● For some computers, you may need to access the audio control panel to
manually set the speaker as the default audio device
To Next Page
Loading...
