2.4G mode connection
Toggle the switch the 2.4G side，the cyan light of the Q key flashes slowly. Then press and hold
FN+Q for 3 seconds and the cyan light flashes quickly to enter the pairing state. At this time,
insert the receiver to complete the pairing. The cyan light of the Q key is on for 2s, and the 2.4G
connection is successful.
*Note: Search first and then insert the receiver when connecting to 2.4G. The factory setting
default is already paired.
Wired mode connection
Toggle the switch to the middle to turn off the keyboard. Insert the USB cable to switch to wired
mode. The Y key lights up. Long press FN to prompt the current mode. The corresponding
indicator lights up white.
BT mode connection
Toggle the switch to the BT mode make sure that the keyboard is under the BT mode:
1. Press Fn+E/R/T and the indicator light blinks in blue fast, the keyboard is ready to pair.
2. Turn on your BT device and find"AULA F65 BLE5.0/BLE3.0", then
connect. When the keyboard is connected to the BT device, the indicator
stops flashing and the connection is done.
3. Press Fn+ E/R/T to toggle between the BT devices 1/2/3.
When the Fn key is held, E/R/T key lights up in white to indicate the keyboard is connected to the
corresponding BT device.
Battery check
FN key flashes red light = low battery
FN key lights up red = charging
FN key lights up green for 2s = fully charged
FN+B displays keyboard’s battery power level."1!-0)" keys lights up green indicates battery
percentage(for example,1!-6^ keys lights up green means 60% power）.1！-4$ lights up red
when the battery level is below 40%.
Operating instructions
To Next Page
Loading...
