41
EN
REMOTE CONTROL
Battery installation
1. Press the tab on the battery door and lift it o.
2. Install two (2) x LR03 (AAA) size batteries into the battery compartment
as the gure on right and the polarity markings inside battery
compartment.
3. Replace the battery door.
Battery precautions:
Follow these precautions when using a battery in this device:
• Use only the size and type of battery specied.
• Besure to follow the correct polarity when installing the battery as
indicated in the battery compartment. A reversed battery may cause
damage to the device. batteries to prevent damage or injury from
possible battery leakage. manufacturer's directions).
• Do not dispose of battery in re. Battery may explode or leak.
• Clean the battery contacts and also those of the device prior to battery
installation.
• Do not mix dierent types of batteries together (e.g. Alkazline and
Carbon-zinc) or old batteries with fresh ones.
• If the batteries in the device are consumed or the device is not to be
used for a long period of time, remove them.
• Do not try to recharge the battery not intended to be recharged; it can
overheat and rupture.
To Next Page
Loading...
Need help?
General
