23
Playback
• Select “Tape” function (6).
• Put in the cassette tape.
• Press Play key to active playback
• Adjust the volume control (19) to the desire level.
• Use pause key when you want to stop playback temporarily.
• Press Stop / eject key when nished.
Remarks: It is possible to play both cassette players one after the other. If you press the button “Pause” and
“Play” at deck 1 and button “Play” at deck 2, than the tape of deck 1 will be start to play automatically after
the tape of deck 2 is nished.
Recording
A. Recording from tape (deck 2 to deck 1)
This unit enables you to duplicate a pre-recorded tape to another tape. It is performed only one way
from deck 2 (playback) to deck 1 (recording).
Dubbing at normal speed
• Select “ Tape ” function (6)
• Inset a pre-recorded cassette into deck 2 and a blank cassette tape into deck 1
• Press the “ Pause ” key and then press the “ Record ” and “ Play ” key at deck 1.
• Press the “ Play ” key to start playback at deck 2 & then press “ Pause ” key at deck 1 to start
dubbing.
• Press “ Pause ” key at deck 1 & “ Stop ” key at deck 2 when nish.
Dubbing at high speed
This unit is equipped with a high speed dubbing system which can save the time for dubbing by 2/3
when compare to normal speed.
• Press the “ Dubbing “ button (23) to “ Hi “ position and then follow the same procedures as stipu-
lated in “Dubbing at normal speed”.
• When dubbing a pre-recorded cassette tape at high speed, a chattering sound is being heard. To
avoid this, set the volume control to a minimum level.
• Do no active/de-active the “Hi-nor. dubbing” button during dubbing, this will vary the speed of
recording and may be damage the cassette tape.
B. Recording from radio
• Select “ Tuner ” function (6).
• Tune to the desire station and insert a blank cassette tape in deck 1.
• Press “Record” & “Play“ key to start recording.
• Press “Pause” keys and then “Stop/eject” key when nish.
To Next Page
Loading...
Need help?
General
