29
EN
LINE OUT
You can connect the unit to a stereo system via the line output (23). Connect
the line output to the AUX input of the stereo system: Use an RCA cable (not
supplied.
Notes:
• The sound from the built-in speakers will not be interrupted, even if the
device is connected to a Hi-Fi system. Turn the volume to a minimum.
• The unit automatically switches to standby mode if no music is played
for more than 15 minutes.
RECORDING
The device is able to make recordings from the board/AUX/Line-IN and
save them in MP3 format on USB/SD.
Recording from the board
1 Set the switch (5) to „Phono/Aux“ and press „REC“ (8).
2 The indicator (8) lights up. The system is ready for recording.
3 Start playback.
4 To stop recording, press the button (8) again.
Note: The recording speed is 1:1 to the playback speed. To stop
recording, press the „REC“ button (8) and recording will pause. To
resume recording, press button (8) again.
AUX-IN Recording
1 Connect an external device using the AUX IN connector (24).
2 Set the switch (5) to „Phono/Aux“ and press „REC“ (8).
3 The indicator (8) lights up. The system is ready for recording.
4 Start playback.
5 To stop recording, press the button (8) again.
Title separation (remote control)
During recording, you can separate the tracks by pressing the „TS“ button.
A new title is created, the indicator (12) lights up once if successful and
recording continues.
To Next Page
Loading...
