11
3 - OPERATING INSTRUCTIONS
Caution! The heater must be properly installed before it is used.
3.1 REMOTE CONTROL
The remote control must be pointed in the direction of the receiver on the heater junction box. (located on the
right side of the heater). The remote must be in line of sight of the heat level indicator when the user intends to
adjust the power level. The remote must be used within a maximum distance of 6 m.
In remote mode the heater has 6 power levels. The power level can be selected with the remote. The selected
power level is displayed on the screen on front of the heater. The remote mode only works with the remote
control supplied with the product. L0 represents standby while L6 represents the maximum heating level.
3.1.1 OPERATION OF THE REMOTE CONTROL
The heater goes directly to the highest heating level (short delay
on start).
To switch the heater ON: Press On.
The heater has a soft start function using only 16% of maximum
power. 4 seconds after the heater has been turned on, it will
automatically switch to the last heating level used. In case of the
first-time use, after 4 seconds the heater will automatically switch
to 100% power.
To switch the heater OFF: Press OFF. The heater will switch to
Standby mode (the receiver indicator will light up).
Notice:
1. Use 2 pieces AAA, 1.5V batteries (not included) in the remote control. Remove the batteries when not in use for an
extended period of time to increase battery life.
2. Contact your local authorized Aura Dealer for remote replacement.
3. The remote-control function may not work if there is a barrier between the remote control and heater.
4. Replace the batteries as required to ensure correct remote functionality.
To Next Page
Loading...