After setting up, the Coordinator will assign the
Wiring Centre a number. This is because more
than 1 Wiring Centre may be used on a project.
Pressing the network button will illuminate the
relevant number. The example shown is for
Wiring Centre 1. If 1 and 2 are lit it would be
Wiring Centre 2.
The JGBR default setting is RX1 (Wireless Boiler Receiver). In this
mode, the JGBR will switch on the boiler in response to a call for heat.
To set as a wireless receiver, switch to RX2. The wireless receiver will
be paired to just one chosen thermostat on the network. This
thermostat will switch the wireless receiver when there is a call for heat.
JGBR set-up -
Wireless Boiler Receiver or Wireless Receiver
Identifying the Wiring Centre
09
speedfitUFH.co.uk
To Next Page
Loading...