IMPORTANT:
Pressing any function button for the first time always turns on the backlight, and then
the function of a specific button.
Clock calibration
This function is used to correct the clock indications in case of any deviations. If the clock is working
incorrectly within a week, the extent of incorrect clock indications should be determined. This value
should be entered in AURATON Libra in the form of seconds.
Example 1:
After a week of operation, AURATON Libra shows time accelerated by 1 minute and 20 seconds (60 +
20 = 80). In this case you should slow down the clock by setting C -80.
Example 2:
After a week of operation, the clock in AURATON Libra is 2 minutes slow (2 x 60 = 120). In this case
you should speed up the clock by setting C 120.
IMPORTANT:
The number of seconds should be determined after one week of operation of AURATON
Libra for the clock calibration function to work correctly (7 days = the number of
seconds to be added or subtracted, maximum 294 seconds).
IMPORTANT:
If no button is pressed for 10 seconds while changing the configuration settings,
AURATON Libra will return to the normal operating mode.
To Next Page
Loading...
