AURATON RT - Regulator Reset Functions; Basic Regulator Reset; Master Reset Function; Troubleshooting Special Situations

11
RESET of the regulator
MASTER RESET of the regulator
Special situations
Pressing the RESET buon ( ) causes the me and day seng to be erased, and the
regulator to be restarted.
The MASTER RESET funcon restarts the regulator and restores factory sengs. This
funcon is invoked by pressing the and RESET buons simultaneously.
NOTE: All user-dened programs will be erased!
• When 3 consecuve transmissions (aer 15 minutes) from the AURATON R25 RT
regulator and/or the T-2 thermometer are lost, an error is signalled on the RT receiver
(LED ashing connuously red and green). The RT receiver starts execung the ON
- OFF cycle memorised during the last 24 hours of operaon unl the problem is
removed.
• When both signals return (from the AURATON R25 RT regulator and the T-2
thermometer), the error is cancelled and the receiver enters its normal mode of
operaon.
• When only the T-2 thermometer signal returns, the receiver uses the last memorised
setpoint value and maintains it while signalling the error.
• When the H-1 handles, the T-2 thermometer and the AURATON R25 RT regulator (the
temperature is measured with the T-2 thermometer) are paired with the receiver,
then maintaining the work cycle from the last 24 hours occurs only aer losing the
signal from the T-2 thermometer. When only the signal from the AURATON R25 RT is
missing, the RT receiver automacally maintains the last memorised setpoint from the
AURATON R25 RT regulator and also signals an error.
• When you have only the H-1 handles and the T-2 thermometer paired with the RT
receiver without the AURATON R25 RT regulator, the RT receiver maintains a constant,
factory-dened temperature of 20°C. If you pivot any window equipped with the H-1
handle paired with the receiver, a temperature of 17°C is maintained. If you open
any window equipped with the H-1 handle paired with the RT receiver, the receiver
switches o the heang device, but will switch it back on when the temperature falls
below 7°C.