EasyManua.ls Logo

AURATON RT - Cooperation with Window Handles; Window Closed or Ventilated; Window Pivoted; Window Opened

AURATON RT
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Cooperation with the AURATON R25 RT regulator and/or the
AURATON T-2 thermometer as well as the AURATON H-1 handles
By default, the AURATON RT receiver does not have any AURATON H-1 handle or
AURATON W-1 window posion sensor paired, therefore the relay is controlled by the
paired AURATON R25 RT regulator and/or the AURATON T-2 thermometer. When at least
one H-1 handle is paired with the RT receiver, the relay is controlled in the following
manner:
A) The window is closed or trickle-venlated (micro-venlaon).
When the H-1 window handles is paired with the receiver, and all windows are closed
or trickle-venlated, the relay sll maintains the setpoint from the paired AURATON
R25 RT regulator and/or the T-2 thermometer.
B) The window is pivoted.
If at least one window is pivoted, the temperature set in the AURATON R25 RT regulator
is lowered in AURATON RT receiver down to 3°C. This state will be maintained unl
closing. This state will last unl all windows are closed or trickle-venlated.
C) The window is opened.
When you open a window equipped with the H-1 handle paired for longer than
30 seconds, the relay in the AURATON RT receiver is switched o, as is the connected
heang device. If all the assigned windows are again in a state other than “opened”,
the RT receiver returns to normal cooperaon with the AURATON R25 RT regulator
and/or the T-2 thermometer no earlier than 90 seconds aer switching o the relay.
The purpose of this delay is to prevent too rapid transions of the connected heang
devices between the ON and OFF states. However, if the temperature in the room
drops below 7°C, the relay inside the receiver is switched on regardless of the posions
of windows in order to prevent the room from freezing.
D) The signal is lost.
When the RT receiver has lost the signal from the H-1 handle paired (3 consecuve
transmissions are lost), it changes the status if this window to “closed”. When the
transmission is restored, the H-1 handle is again properly read o by the RT receiver.

Related product manuals