Need help?Do you have a question about the AURATON RTH and is the answer not in the manual?
Saves last 24h heating cycle for backup during communication loss with controllers.
Explains the meaning of LED lights for OFF, ON, IN, OUT, ALARM, and RESET states.
Explains the process of pairing the RTH receiver with system devices like the T-1 controller.
Procedure to remove a single device previously paired with the RTH receiver.
Process to deregister all devices associated with the RTH receiver simultaneously.
Explains temperature control via two-state algorithm using sensors.
Enables manual temperature setting and control directly from the T-1 controller.
Allows remote temperature control using a T-2 thermometer, overriding T-1 settings.
Details conditions for AC control: no T-1/T-2 association, at least one H-1 handle.
Describes receiver behavior and failure signals for lost T-1/T-2/H-1 transmissions.
To Next Page
General
