1. User-installable SSD/HDD Slots
The A200 is supplied 2 bays for user-installable storage. The unit does not include
built-in storage. If it is your intent to import and store digital audio files on the N20,
you will need to install the appropriate hard drive(s)/SSD(s) first. Please refer to the
“ ”
SSD/HDD Installation Guide
2. Analog Audio Output – RCA Right
3. Analog Audio Output – RCA Left
4. Digital Audio Input - Coaxial SPDIF (RCA)
5. Digital Audio Input - Optical SPDIF (Toslink)
6. Dedicated proprietary USB Audio Class 2.0 Output
Aurender's filtered and isolated USB port is designed to connect to asynchronous
USB DACs. Use a USB 2.0 certified A/B cable to connect with a compatible USB DAC.
7-8. USB 3.0 Data Port
These USB data ports can be used to copy files from USB memory devices or for
connectivity with compatible external control devices (eg. dCS USB-to-RS232
dongle, MSB Prol25-to-Clock module, Constellation preamps, etc.). For best audio
performance, these ports should not be used as USB audio outputs.
9. Double Isolated Gigabit Ethernet Port
This model uses 2 transformers in the Ethernet port circuit for superior noise
filtration without detrimental signal loss.
The Aurender must be connected to your Local Area Network via Ethernet (CAT5 or
higher). In case there is no Ethernet connection available in the location where your
Aurender is to be installed, please see the following support article for other options:
What if I do not have an Ethernet/LAN connection in my listening room?
10. AC Power Switch
To Next Page
Loading...