mSATA Drive installation
*FYI, the SAMSUNG mSATA is an example of the mSATA drive which is compatible with the FLOW
*Please follow the instructions below when installing a new mSATA SSD.
Remove the 4 screws on the rear panel of the main case.
While holding the top part, let the bottom part softly fall while opening.
After inserting and connecting the mSATA SSD in proper direction, press the clip until the mSATA SSD is
secured.
After installing the mSATA SSD, replace the cover and screw in all four screws firmly.
When replacing the cover, take extra care to make sure that the battery cables are not jammed between the
top and bottom parts.
After installation of mSATA drive.
1. Make sure the host mode is set to USB2 or USB3 or Mac. It depends on the the Host computer you are using
2. Set the mSATA mode menu to mSAT+
3. Please format the mSATA drive using the format menu of the operating system of your computer. Format
menu will differ depending on the PC/Mac's operating system.
To Next Page
Loading...