Battery Charging
It is strongly recommended that only the provided battery charger be used.
Should another charger type have to be used, the output voltage must be 5V/2A.
Although the time can vary according to various conditions, it usually takes 3-4 hours to charge the battery.
Please note that with all re-chargeable batteries (Li-ion), the length of play time between charges will slowly
decrease as time passes.
For fastest charge, please use the AC Adapter enclosed with the FLOW.
Using the USB 2.0 port of PC for charging will be very slow because it can draw only 500mA from the port.
When the mode is iOS or anDR, FLOW will not be charged from the device not to draw current from the
phones.
Technical Specifications
Product Name: Aurender FLOW
Model Name: V1000
DAC Chip:ESS9018K2M
USB Interface & controller: XMOS XS1-U8A-64-FB96
USB Audio: USB Audio Class 2.0
USB Interface:USB 3.0/2.0
Audio Output Termnial:1/4 inch(6.35mm) Headphone Jack
Max Audio Output Level:5.1Vrms
mSATA Slot: For Optional mSATA storage (User installable)
THD+N Max -114d: B
IMD(SMPTE) : Max -112dB
Dynamic Range: Max 122dB
Output Power:
600 ohm -> 43mW
300 ohm -> 87mW
56 ohm -> 384mW
32 ohm -> 570mW
8 ohm ->180mW
Output Impedance: Max 0.06 Ohm
Damping Factor: >130
THD+N: 0.0002% (1kHz 5.1Vrms output)
SPDIF Mode(Optic) : Up to 24bit /192kHz sample rate
PCM mode(USB) : Up to 32bit/384kHz sample rate
DSD Mode (USB) : DSD64, DSD128 / Native DSD through DoP Mode
Battery: Samsung Li-ion 4450 mAh
AC Adapter for Battery Charging: DC 5V/2A USB A Type
Unit Dimension: 80 x 137 x 28 (mm)
Unit Weight: 450g(mSATA excluded)
Charging Time: 4~5 hours
Play Time: 7 hours / 300 ohm Headphone
To Previous Page
Loading...