Auriol 4-LD6032 - Page 19

- 16 -
at the drilling location. Note the condition
of the wall. The enclosed fastening material
is not suitable for all types of wall.
The manufacturer accepts no liability for
damage caused by incorrect mounting.
 Set up the stand (28) in order to
position the device securely.
 Be sure to protect sensitive surfaces
before setting up the device, otherwise
scratches may occur.
Make sure that:
 there is always sufficient ventilation (do
not place the device on shelves or
where curtains or furniture cover the
ventilation slots (29) and leave at least
10 cm clearance from the side);
 the device is not placed on a thick
carpet or bed during operation and
that no direct heat sources (e.g.
heaters) impact the device;
 the device is not exposed to direct
sunlight;
 contact with splashing and dripping
water is avoided;