10 GB
Risk of damage of the product
Only use the specified type of battery / rechargeable battery!
Insert batteries / rechargeable batteries according to polarity
marks (+) and (–) on the battery / rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean the contacts on the battery /
rechargeable battery and in the battery compartment before inserting!
Remove exhausted batteries / rechargeable batteries from the product
immediately.
Before initial use
Remove the battery from the box and plastic wrapper. Insert the battery into
the battery compartment, placing first the – contact and then pushing down at
the + contact.
Replacing the battery
Turn the wall clock over. Place it on a soft underlay to avoid scratching the
surface.
Remove the battery and then insert a new battery with the correct polarity.
Make sure to first insert the battery into the battery compartment from the
negative terminal. Then, press down the positive terminal of the battery.
The wall clock is now ready for use.
Radio Signal (DCF for HG06544A,B, MSF for HG06544A,B-BS):
HG06544A,B:
The DCF signal (time signal transmitter) consists of time pulses emitted by one of
the most accurate clocks in the world. This clock is located close to Frankfurt /
Main, Germany and it can usually achieve an accuracy within a hundredth of a
second relative to the time standard.
Your radio-controlled wall clock receives these signals under ideal conditions up to
a distance of approx. 1,500 km around Frankfurt / Main. Reception of the radio
signal generally takes approx. 3 to 12 minutes.
To Next Page
Loading...
Need help?
General
