Auriol Z30239A - Setting the Time Manually

12 GB/IE
Operation
The reception of the DCF radio time signal by the alarm clock can
also be started manually.
Press and keep pressed the REC button
5
for a short while.
The alarm now starts to receive a signal again.
Note: If the alarm clock was not able to receive the DCF radio
time signal because of data errors, e.g. due your location to being
at too great a distance from the transmitter or for other reasons,
you can set the time manually.
Setting the time manually
Press the M.SET button
4
for at least 3 seconds. The alarm
clock switches into manual mode.
Press and keep pressed the M.SET button
4
again until the
hands reach the correct position for you to set the time. Release
the M.SET button
4
when the hands have reached the desired
position.
Briefly pressing the M.SET button
4
moves the hands forward
in one minute steps to enable you to set the current time manually.