Aurora AS420C - Operation Details; Shredding Paper and Credit Cards; LED Status Indicators

6 ENGLISH
OPERATION
CONTINUED NEXT PAGE

Paper/CreditCardEntry:
 NOTE:
•Always turn off and unplug the shredder when not in use.
•This shredder will shred staples and small paper clips. It is recommended that you remove paper clips
whenever possible to extend the lifespan of your shredder.
•Only shred credit cards by feeding them vertically i nto the middle of the entry, releasing when
shredding begins. Never feed more than one credit card at a time.
•Overfeeding the shredder: Shredding beyond the specified sheet capacity can result in extensive
damage to the shredder. Overfeeding will strain the machine and quickly wear and break the cutting
blades and internal components.
•Overheating with extended use: In the event that the shredder has shred continuously beyond the
maximum running time and overheating, the unit will automatically shut off. If this happens, switch
the shredder off for 15 minutes or longer before resuming normal operation.

Make sure you do not exceed sheet
count per pass (4 sheets max).
Insert paper as straight as pos-
sible into feed slot and release.

Insert one credit card at a time into
the middle of the feed slot.
•Ready(PowerOn):
The Green LED light indicates the shredder is “On” and ready to operate when paper is inserted.
•Overheat:
The Red LED light indicates the shredder has shred continuously beyond the maximum running time
and overheating, the unit will automatically shut off. If this happens, switch the shredder off for 15
minutes or longer before resuming normal operation.

LEDStatusIndicators:
Ready(PowerOn)/Overheat