2
insert the battery in its designated housing in the
Battery Charger.
a. Push the battery towards the contacts on the
Battery Charger.
b. Push the battery downwards.
Charge starts, and it is signalled by CHARGE
LED steady on (see paragraph 3.1 "Max. recharge
time").
NOTE: do not force insertion. The battery slides
easily into place and ensures that the positive (+)
and negative (-) poles are correctly connected
only if it is inserted with the plate facing the
compartment, so that the battery's contacts match
the Battery Charger 's contacts.
2a2a
2b2b
3
The battery is fully charged when the CHARGE
LED switches o. To remove the battery:
a. Push the battery towards the contacts on the
Battery Charger.
b. Lift the battery.
If you leave the battery in the battery charger after
charging has been completed, the battery charger
can start recharging again. This compensates
self-discharge (if any).
Do not, in any case, leave the battery under
charge for prolonged time when it is not in use.
3a3a
3b3b
AUTEC -
MBC825A (80-250V) and MBC825A (110V) battery chargers 23
LIUMBS001_eng-02
To Next Page
Loading...
