57
5.
Reboot the remote controller and aircraft before use.
NOTE
• Do not turn off any device or take out your SD card from the camera
during the process. Do not start the motors.
• After the upgrade is completed, the remote controller may be
disconnected from the aircraft, and you will need to rebind the devices.
Troubleshooting Tips
Should you have any issues operating the product, read this section for possible
solutions.
When the aircraft indicates failure during self-check (with 4 LED lights ashing
quickly in red and the buzzers beep continuously)
• Hardware proplems detected and you need to contact the Customer Service
When the aircraft motors fail to start up
• Check if the remote controller and the aircraft are properly bound
• Check if the remote controller is properly calibrated
• Check if the battery level is below 15%
• Check if the compass is experiencing interference
• Make sure the Flight Mode Switch is not in the GPS position if the GPS
signal is not strong enough
• Make sure GPS is available when Beginner Mode is activated
When take-off fails after motors start
• Check if the aircraft is in a no-y zone
• Make sure the aircraft is placed on a at, leveled surface
When the aircraft’s ight time reduces
• This is possibly due to low temperature of the operating environment or
increased take-off weight
When pairing up, the aircraft does not respond to the remote controller
• Make sure there are no metal objects, wireless sources or other remote
controllers around
If Video link fails or disconnects frequently
• Make sure your aircraft and remote controller are free from all magnetic or
signal interferences
To Next Page
