8
To charge battery by power adapter.
1) Locate the power port of the device.
2) Connect the device and the power source with the adapter.
To charge battery by USB cable
1) Locate the USB port of the device.
2) Connect the device and the computer with the USB cable.
For optimum performance, always keep your tool sufficiently
charged. It is recommended that you charge the tool for over 2 hours
before the first use.
NOTE: Only use the power adaptor or USB cable that is
included in our pack to charge this tool. The use of
un-approved power supplies may damage your tool and void
the tool warranty.
3.7 Power Up by DLC
The tool can also be powered via the vehicle Data Link Connector
(DLC). Just follow the steps below to turn on the TPMS tool:
1) Connect the OBDII Cable to the TPMS tool.
2) Find DLC on vehicle.
A plastic DLC cover may be found for some vehicles and
you need to remove it before plugging the OBDII cable.
3) Plug OBDII cable to the vehicle’s DLC.
4) Power up the TPMS tool by pressing the Power button
,
a
nd wait for the Main Menu to appear. (Figure 3.1)
To Next Page
Loading...
Need help?
General
