PROGRAMMABLE UNIVERSAL
I MX-Sensor433MHz
Email: sales@auteltech.com
Web: www.auteltech.com
SAFETY INSTRUCTIONS
Before installing the sensor, you must read the installation and safety instructions carefully. For reasons of safety and
for optimal operation, we recommend that any maintenance and repair work is carried out by trained experts only and
according to the guidelines of the vehicle manufacturer. The valves are safety-relevant parts which are intended for the
professional installation only. Failure to do so may result in the failure of the vehicle TPMS sensor to operate properly.
AUTEL does not assume any liability in case of faulty or incorrect installation of the product.
CAUTION
• The TPMS sensor assemblies are replacement or maintenance parts for vehicles that have a factory installed TPMS.
• Make sure to program the sensor by AU TEL sensor programming tools for your specific vehicle make, model and
year before installation.
• Do not install programmed TPMS sensors in damaged wheels.
• In order to guarantee optimal function, the sensor may only be installed with original valves and accessories
provided by AU TEL.
• Upon completion of installation, test the vehicle TPMS system using procedures described in the original
manufacturer's user guide to confirm proper installation.
WARRANTY
AU TEL guarantees that the sensor is free from material and manufacturing defects for a period of twenty-four (24)
months or for 24,000 miles, whichever comes first. AUTEL will at its discretion replace any merchandise during the
warranty period. The warranty shall be void if any of the following occur:
I.
Improper installation of products
2. Improper usage
Induction of defect by other products
3.
4. Mishandling of product
Incorrect application
5.
6.
Damage due to collision or tire failure
7.
Racing or competition
Exceeding the specific limits of the product
8.
EXPLORED VIEW OF SENSOR
J.
EXPLORED VIEW OF SENSOR
Technical data of the sensor
Weight of sensor without valve:
Dimensions:
Max. pressure range:
S c reW
• Sensor
Valve stem,
rubber grommet
and valve
core assembly
Washer
Screw -nut
Cap
18.5 g
approx. 55.1*29.4*21.8 mm
800 Kpa
CAUTION: Each time a tire is serviced or dismounted, or if the sensor is removed or replaced, it is mandatory
to replace the rubber grommet, washer, nut and valve core with our parts to ensure proper sealing.
It is mandatory to replace the sensor if it is externally damaged.
Correct sensor nut torque: 4 Newton-meters.
To Next Page
Need help?
General
