Auto Ventshade Windflector User Manual

Installation Instructions
Windflector®
I - Sheet Number WF01 Rev.A
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the roof wind deflector is properly secured to vehicle.
• Do not use automatic “brush-style” car washes.
• Do not use cleaning solvents of any kind.
• Periodically check that all components are secured.
Contents
NOTE: Actual product may vary from illustration.
Preparation Before Painting / Installation
Page 1 of 2
Car Wash Supplies Masking TapeClean Towel
Alcohol Pad x2
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Wash and dry roof thoroughly.
1
Roof Wind Deflector
2
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash your vehicle’s roof to remove any debris and/or dirt.
• Dry the roof with a clean towel.
Tools Required
Clean roof wind deflector mounting location
with an alcohol pad.
sunroof opening
top view

Auto Ventshade Windflector Specifications

General

Brand	Auto Ventshade
Model	Windflector
Category	Automobile Accessories
Language	English

Summary

Important Safety Information

Tools Required

Preparation Before Painting / Installation

Installation Steps

Wash and dry roof thoroughly

Prepare the vehicle's roof by washing and drying it thoroughly before proceeding with installation.

Clean mounting location with alcohol pad

Use an alcohol pad to clean the specific roof area where the deflector will be mounted.

Center and mark roof deflector position

Center the roof wind deflector on the roof and mark its edges for accurate placement.

Peel tape liner from flange ends

Partially peel back the tape liner from each end of the deflector's flange for initial adhesion.

Position and press deflector

Place the deflector on the roof, align with marks, and press lightly on exposed tape areas.

Remove tape liner

Remove all masking tape and pull free ends to remove the remaining tape liner, securing the deflector.

Apply pressure for adhesion

Apply firm pressure along the deflector's flange edges to ensure proper and lasting adhesion.

Care and Cleaning