NOTE: Actual application may vary slightly from illustrations.
Installation Steps
Page 2 of 2
3 4
5 6
Peel back 2” (5 cm) of tape liner from each end of
flange.
Position roof wind deflector on roof and align with
previously marked locations. Press lightly on ex-
posed areas of tape and verify positioning.
With the roof wind deflector in its final position,
remove masking tape, and remove remaining tape
liner by pulling on free ends.
Center part on roof, and mark edges for
reference with masking tape.
equal distant
from front
windhsield
and side to
side
free end free end
7
Apply pressure along flange edges to ensure proper
adhesion.
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
© 2005 Lund International, Inc. All rights reserved.
Auto Ventshade
TM
, the Auto Ventshade
TM
logo and the AVS
TM
logo are trademarks of Lund International, Inc.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
™
To Next Page
Loading...