Note
(1)
Once you have the camera down,route the camera wiring
into
the vehicie. It is best to
find
an existing grommet to
run the wiring through.if
necessary,
drill
a hole to run the wiring
into
the vehicle.If you use this method,be sure to use a
rubber grommet to protect the wiring.
(2)
Using the test pencil to test which cabie is reverse
light.
And connect the black wire to any metal screw.
(3)
Please
mind "+/-" of the wires. Use electricai tape to
seai.
"1
05
To Next Page
Loading...