AutoAnchor AA570 User Manual

39
4.5.4.4 Deploy the Anchor Using Automatic Operation
Turn the AA710 on.
Clear the safety lock.
Press the Mode button to enter the Menu.
Press the Mode button again to select Auto. The screen
displays the current length for Auto release. If this setting is
correct, press and release the down button to deploy the
anchor.
To Change the Setting:
Press the Mode button again to select Set auto.
Scroll to the value.
Save and return to Auto.
The windlass will stop and the AA710 will beep when the
preset length of rode has been released. The screen will
display “Target reached”.
4.5.4.3 To Set A Rode to be Released Value
Turn the AA710 on.
Clear the safety lock.
Press the Mode button to enter the menu.
Press the Mode button twice to enter Set auto.
Scroll up or down to the value.
Save and return to start screen.
To disable automatic operation: Set the rode to be released value to Off.
4.5.4.2 Enable Automatic Operation
A “rode to be released” value must be entered to use automatic operation.
4.5.4.5 Retrieve the Anchor Using Automatic Operation
Turn the AA710 on.
Clear the safety lock.
Press the Mode button to enter the Menu.
Press the Mode Button again to select Auto.
Press and release the Up button to retrieve the anchor.
The windlass will stop and the AA710 will beep when
the docking distance is reached. The screen will display
Docking distance. If the system is set up for dual speed,
it will change to slow speed at this point.
Press and hold the Up button to complete retrieval of the
anchor. The AA710 will beep during this process.
Select Mode
Lock
Clear to Zero
Select Mode
Lock
Clear to Zero
Select Mode
Lock
Clear to Zero
Ensure the anchor is fully docked and secured before moving the boat.

AutoAnchor AA570 Specifications

General

Brand	AutoAnchor
Model	AA570
Category	Remote Control
Language	English