EasyManuals Logo

Autocable Drop-in 6 User Manual

Default Icon
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
5. UNPACKING AND PREPARATION
The Autocable machine is delivered partially dismantled. Can be supplied assembled or
packaged in cardboard to facilitate the operations of handling and transport before the
operation by the user.
To transport the machine in these conditions it is indispensable to use a transpallet or
similar with a load capacity of around 70 kilos.
Avoid:
hoisting the autocable machine with ropes or unsuitable hoists;
drag Autocable machine with the device in contact with the burial ground;
bumps or shocks;
exposing the machine to rain, frost or any bad weather.
On taking delivery check that the contents correspond with the delivery note.
Should damage or deformity due to transport be noted, make an immediate compliant to
the carrier and advise the authorised dealer or the manufacturer. In particular, check that:
there are no dents, signs of bumps or deformations;
there are no damp areas or signs the may lead to suppose that the pack has been
exposed to foul weather;
there are no signs of tampering;
After checking that transport has been carried out correctly, proceed to assembling the
machine as shown in figures 5a/b/c.
Open the box, making sure that the card is oriented in the right direction.
Remove the machine from packing.
Place the handle in the transport position and lock it securely.
All the machines can be lifted and transported by means of cranes or winches, using hooks
and cables, which must be approved and of an adequate capacity. Hook up to the lugs, as
shown in the pictogram affixed to the machine.
Only safe hooks, such as snap hooks, must be used for lifting. Take great care and
exercise extreme caution when loading and unloading the machine. These operations must
only be carried out by qualified personnel (slingers, truck operators, etc.). Never pass or
stand underneath the machine when it has been raised off the ground.
To transport the machine, grasp the handle and push in the desired direction with the
engine switched off.
1
Fig.4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Autocable Drop-in 6 and is the answer not in the manual?

Autocable Drop-in 6 Specifications

General IconGeneral
BrandAutocable
ModelDrop-in 6
CategoryConstruction Equipment
LanguageEnglish