What to do if my AUTOFRY MTI-10 with RTD Fryer display is blank but the fan is on?
If your AUTOFRY Fryer's display is blank while the fan is running, the issue might be an open safety. You should inspect all safeties, ensure the fan is working correctly, check the fire system gauge, and inspect the filter. Also, verify and adjust the airflow switch.
What to do if my AUTOFRY MTI-10 with RTD Fryer heater fails to reach the set point in 16 minutes?
If the heater in your AUTOFRY Fryer isn't reaching the set temperature within 16 minutes, you should check the supply voltage, the supply breaker, and the limit reset. Also, examine the voltage at the heater plug. As an additional step, you can unplug the fryer from the power supply or press the OFF button.
What to do if my AUTOFRY MTI-10 with RTD shows a temperature difference of 50 degrees in 5 seconds?
If your AUTOFRY Fryer shows a temperature difference of 50 degrees in a 5-second period, verify the oil level and condition. You can also try unplugging the fryer from the wall to reset the board. Alternatively, press the OFF button and unplug the fryer from the supply.
How to resolve frequency conflict or thermocouple short in AUTOFRY Fryer?
To resolve a frequency conflict or thermocouple short in your AUTOFRY Fryer, start by checking the installation of the yellow thermocouple and the condition of the cord. Also, check the TC1 connections on the circuit board and the connections at the thermocouple socket in the heater box, ensuring that yellow is (+) and red is (-).
What to do if basket motor is not in position after 10 seconds in AUTOFRY MTI-10 with RTD Fryer?
If the basket motor in your AUTOFRY Fryer isn't in position after 10 seconds, check for broken gears, all wire connections, switches, and the tightness of the switch cam. As an additional step, you can unplug the fryer from the power supply or press the OFF button.
How to check RTD or Thermocouple Probe in AUTOFRY MTI-10 with RTD Fryer?
To check the RTD or Thermocouple Probe in your AUTOFRY Fryer, inspect the plugs and sockets, and the probe itself. Also, check the condition of all cords and connections. See also A07.
Electrical requirements for the AUTOFRY FF6-10 model.
Electrical requirements for the AUTOFRY MTI-10 model with RTD.
Electrical requirements for the AUTOFRY MTI-10 model with Thermocouple.
Instructions for connecting electrical service to the AUTOFRY unit according to codes.
Connecting the RTD/Thermocouple and heater plugs to the heater box correctly.
Connecting the AUTOFRY to power and turning it on for the first time.
Initial steps to power on and preheat the AUTOFRY unit before cooking.
How to enter cook times and start the cooking cycle for food products.
Understanding the stages of a cooking cycle, including basket movement and draining.
Requirements for inspecting the fire suppression system every six months.
Procedures for testing the safety system, including airflow and interlock switches.
Detailed steps for testing the airflow switch by blocking exhaust flow.
A table detailing error codes, their conditions, diagnostics, and reset procedures.
To Next Page
General