Automatic Filters Tekleen CSB - Page 19


-17-
0.1- 1 second …………………… 0.1 -------------------------------------------------------------------1 second
1 - 10 seconds ………………… 1 --------------------------------------------------------------------10
seconds
6 - 60 seconds ………………… 6 -------------------------------------------------------------------- 60
seconds
1 - 10 minutes ………………… 1 -------------------------------------------------------------------- 10
minutes
6 - 60 minutes ………………… 6 -------------------------------------------------------------------- 60
minutes
1 - 10 h ………………………….. 1 -------------------------------------------------------------------- 10 hours
10 - 100 h ………………………… 10 ------------------------------------------------------------------- 100 hours
NOTE : On 6-60 time range multiply the time set scale by 6.
Example – On-delay of 18 seconds is required.
a. Set the time range knob to 6-60s position.
b. Set the time set knob to 3. (3x6 = 18 seconds.)
3. State indicator Un signals.
a. No light = The timer is in off state. (No supply on A1/A2 terminals)
b. Blinking light = The timer is counting/On delay.
c. Steady light = The timer reached the time set. (Internal relay energized)