9
Please follow these instructions precisely.
1. Press Function Key
The display will change to.
You will notice the cursor is flashing at the first digit on the left of the two digits
Press the key with 3 on it, the cursor will now move to the next digit, now press 0.
Press Enter.
The display will change to.
You will notice the cursor is flashing at the first digit on the left (+)
To Increase Contrast Press The Key “Energy Imp” The contrast will start to go darker.
Keep pressing until you have reached your desired setting
( - ) Press the “Energy Exp” key to lighten the display.
When finished
Press Enter.
The meter will automatically take you back to the default display.
8
Please follow these instructions precisely.
1. Press Function Key
The display will change to.
You will notice the cursor is flashing at the first digit on the left of the two digits
Press the key with 2 on it, the cursor will now move to the next digit, now press 2.
Press Enter.
The display will change to.
You will notice the cursor is flashing at the first digit on the left TO ALTER THE time
Select the number and press the key, the cursor will now move to the next digit to the right.
When finished
Important.
The pulse time can be set from 20ms to 300ms. If it is above 300ms, the default
time is 100ms.
Press Enter.
The meter will automatically take you back to the default display.
The kVah pulse output will automatically be set to the same value.
To change the display contrast
Code 30 (switch 8 on)
To change the pulse closure time
Code 22 (switch 8 on)
To Next Page
Loading...
Need help?
General