Autometers Systems IC 970 User Manual

13
Please follow these instructions precisely.
1. Press Function Key
The display will change to.
You will notice the cursor is flashing at the first digit on the left of the two digits
Press the key with 5 on it, the cursor will now move to the next digit, now press 2.
Press Enter.
The display will change to.
The above display indicates the individual switches which have been switched to the “on”
position on the binary switch.
“0” indicates the switch is in the “OFF” position
“1” indicates the switch is in the “ON” position.
Press Enter.
The meter will automatically take you back to the default display.
12
Please follow these instructions precisely.
1. Press Function Key
The display will change to.
You will notice the cursor is flashing at the first digit on the left of the two digits
Press the key with 5 on it, the cursor will now move to the next digit now, press 1.
Press Enter.
The display will change to.
When you see above display the relay output will open and close once every second. This will
test if the relay is functioning correctly.
When finished
Press Enter.
The meter will automatically take you back to the default display.
Indication of binary switch settings
Code 52 (view)Relay test mode code 51 (switch 8 on)

Autometers Systems IC 970 Specifications

General

Brand	Autometers Systems
Model	IC 970
Category	Measuring Instruments
Language	English