Autonomous Smartdesk 2 - SmartDesk 2 Assembly Steps; Step 1: Separate Crossbar Ends; Step 2: Attach Legs to Crossbar Ends

4
Use the Allen Wrench to loosen eight M6x10 screws.
Separate the Crossbar Ends (P3).
You will find the Crossbar Rails (P4) inside.
Turn the Legs (P1) upside down on their sides.
Place the Crossbar Ends (P3) into the Legs following direction as below pictures.
When positioned correctly, the mount tabs of Crossbar Ends will be facing up.
Insert eight M6x12 screws (P16) into Crossbar Ends - 4 for each side.
Flip the Legs to gain access to all screws and firmly secure both legs.
Crossbar End Crossbar Rail Crossbar End
Crossbar End
Crossbar End