Autool HTS 558 - Frequently Asked Questions (FAQ)

conditions, please adjust the bottom throttle valve of the carbon gun according
to the actual situation to ensure that the firing rate is in the best condition, and
ensure that the carbon removal is perfect and does not hurt the particles.
IV. FAQ
Please check each point before consulting our maintenance department:
Question Possible reasons Solution
The motor does not turn
Check that the power cord
plug is properly plugged in
Plug in the power plug correctly
Check if the power outlet
has power
Check the fuse is open to
ensure that the outlet has
electricity
Check if the machine is
power on
Turn on the power switch
Dust out of the machine
while working
Check if the Haipa
component is installed
Proper installation of Haipa
component
Check if the Haipa
component is defective
Replace the Haipa component
Check if there is a lot of
tiny dust on the Haipa
Cleaning the Haipa
Check if the main straw is
plugged in
Insert the main straw
Weakened suction
Check if the ground brush
hose and the nozzle are
blocked
Clear the blockage in time
Check if Haipa is full of
dust and clogged
Clean up or replace Haipa in
time
Check if the paper bag is
full of dust
Clean or replace paper bags in
time
There will be an electric
shock during use
The air is too dry
Appropriate increase in air
humidity
Friction and electricity
generation with cotton and
linen items such as carpets
Contact and discharge with
other metal objects in the room
during use