Autoscript WC-IP - Wireless Base Station Issues

17
Fault Check
Wireless Basestation
The WB-IP is not
powering up
Check that the power over Ethernet source has a suitable power
injector
Check that the cable from the PoE source is rmly locked into the PoE
input on the WB-IP
Check that a quality Cat5 or Cat6 cable has been used to connect to
the PoE injector
The WB-IP is powered
up, but not controlling
the prompted text
Check that any connections to the WB-IP are correct and secured
Conrm that the WB-IP is enabled in the Devices window
Check that a quality Cat5 or Cat6 cable has been used to connect the
controller to the PoE injector
Check that a quality Cat5 or Cat6 cable has been used to connect the
controller to the PoE injector
The WB-IP is not
discovered on a local IP
network
Check that the WB-IP and the software application are not separated
by an IP gateway
Check that the device is not already connected to another di󰀨erent network
If added to the system manually check the correct details are entered
in the Manually Add Device elds
The WB-IP IP address is
not congured correctly
in the application
Check that the correct IP address has been added for the WB-IP (i.e.
has this IP address been used for a di󰀨erent device)
Troubleshooting