Autostart AS-1214 SH - User Manual

1
Table on contents………………………….. 1
What’s included……………………….……2
Notice….…….…………………………….. 2
Install points to remember………………. 2
Features…………………………………… 2
Options……………………………………. 2
Programmable options………………….. 2
Transmitter code learning………...……. 3
Multi car operation…………………..…. 3
Tach Adjustment………………………… 3
Manual Tach adjustment……….…………3
Custom Programming Options..….…..….. 4
Door lock toggle mode……………..………. 4
Options Playback………………………….. 5
Vacuum mode……………..……………..… 5
Tach watch Lockout……………………….. 5
Idle Mode…………………………………… 5
Diesel Engine.…………………….………… 6
Module Reset…………..……………………6
Secure Lock………………………………… 6
Harness Description………………..….……7
Light Flash Rate……………………………. 8
AS-1200/1203/1204/1205/1214 Wiring
Schematic…………………………………….9
AUTOSTART
AS-1200/1203/1204/1205/1214 SH
Automatic transmission remote engine starter systems.
Rev: 2.01 La - 08/09/01 - Manufactured in Canada by AUTOSTART
INSTALLATION GUIDE
Table of Contents
NOTICE:
DUE TO THE POTENTIAL FOR DAMAGE TO THE VEHICLE, THE MANUFACTURER IS NOT
RESPONSIBLE FOR ANY ELECTRICAL OR MECHANICAL DAMAGE TO THE VEHICLE OR TO
THE UNIT THAT HAS CAUSED VEHICLE DAMAGE DUE TO IMPROPER INSTALLATION OF THE
PRODUCT.
THIS UNIT MUST BE INSTALLED BY AN AUTHORIZED AUTOSTART TRAINED TECHNICIAN
USING ALL SAFETY DEVICES SUPPLIED.
Please review the installation guide carefully before any work begins.
WARNING
THIS UNIT IS FOR AUTOMATIC TRANSMISSION ONLY, BEFORE INSTALLING THE
UNIT TEST THAT THE VEHICLE WILL NOT START IF THE GEAR SELECT LEVER IS
IN A DRIVE POSITION. IF IT STARTS IN GEAR, INSTALL A MANUAL TRANSMISSION
CAR STARTER. (AS-1260M)

Summary

Whats Included and Installation Points

Installation Points to Remember

Key considerations for installing the system safely and correctly in a vehicle.

System Features and Options

Features

Lists the key capabilities and functionalities of the AutoStart system.

Options

Details additional functionalities and services available for the system.

Programmable Options

Describes configurable settings that allow customization of system behavior.

Transmitter and Tach Configuration

Transmitter Code Learning

Process for programming transmitters to the AutoStart system.

Multi Car Operation

How to program a transmitter for multi-car operation on compatible models.

Tach Adjustments

Methods for fine-tuning the Tach signal for reliable remote starting.

Manual Tach Searching and Setting

Step-by-step guide for manual Tach signal adjustment in specific conditions.

Custom Programming and Modes

Custom Programming Options

How to access and configure advanced system settings.

Door Lock Toggle Mode

Enables immediate door locking on first remote press, bypassing factory delay.

System Modes and Troubleshooting

Vacuum Mode

How to configure and use the system in vacuum mode instead of Tach mode.

Tach Watch Lockout

Explanation of the starter protection feature and how to resolve lockout conditions.

Idle Mode

How to enable and use the remote starter to keep the vehicle running.

Specific Engine and Reset Procedures

Diesel Engines

Wiring and considerations for diesel engine installations.

Resetting the Module

Procedure to reset the module to factory default settings and erase transmitters.

Secure Lock

How the secure lock feature works for certain vehicle types.

Harness Descriptions

7-Pin Harness Description

Description of the 7-pin harness, its wire colors, polarity, and connections.

4-Pin Harness Description

Description of the 4-pin harness, its wire colors, polarity, and connections.

5-Pin Harness Description

Description of the 5-pin harness, its wire colors, polarity, and connections.

Light Flash Rate Diagnostics

Wiring Diagram and Connections

Autostart AS-1214 SH Specifications

General

Number of Buttons on Remote	4
Engine Start	Yes
Engine Stop	Yes
Keyless Entry	Yes
Trunk Release	Yes
Security System	Yes
Power Door Locks	Yes
Type	Remote Starter
Remote Start Confirmation	Yes
Security Features	Anti-theft
Operating Temperature	-40°C to +85°C
Battery	12V