Autostart AS-6205 SH User Manual

Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the
Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart
technicians, a certain level of skill and knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.
Warning
This unit is designed for vehicles with an automatic Transmission only.
Before installing the Unit, test that the vehicle will not start if the gear select lever is in the
“Drive” position. If the vehicle starts in gear, install a manual-transmission Car Starter
instead.
H.310 S.3.20 DOC: 1.00 CA – September 15, 2003 Manufactured in Canada by Autostart
AUTOMATIC TRANSMISSION REMOTE STARTER
SYSTEM
AS-6205 SH
Installation Guide

Autostart AS-6205 SH Specifications

General

Brand	Autostart
Model	AS-6205 SH
Category	Car Alarm
Language	English

Summary

6-Pin Main Ignition Harness Wiring

Ignition Harness Wire Descriptions

Details on RED, PURPLE, YELLOW, ORANGE, GREEN wires.

Options Programming - Mode 1

Function 1 - Ignition-Controlled Door locks

Configures door locking behavior based on ignition status.

Function 2 - Secure Lock

Configures secure locking features for OEM alarm integration.

Function 3 - Door Locks Pulse Timing

Sets pulse durations for door lock/unlock operations.

Function 4 – AUX 3 Programming

Configures the AUX 3 output for trunk or other functions.

Function 5 – AUX 2 Programming

Configures the AUX 2 output for priority door access or car finder.

Options Programming - Mode 2

Options Programming - Mode 3

Auto Tach Programming Procedure

Multi-Speed Tach Programming

System Testing Procedures

Remote Start and Starter Drag Test

Checks for proper remote start operation and starter drag.

Hood Switch Shutdown Test

Verifies the hood switch function for shutdown.

Brake Shutdown Circuit Test

Verifies the brake pedal shutdown functionality.

Shock Sensor Testing and Settings

Covers mounting, setting, and testing shock sensors.

Shock Sensor Setting and Testing

Ignition-Controlled Door Locks Configuration

Ignition Lock Disabled

Disables ignition-controlled door locking.

Ignition Lock Enabled

Enables door locking/unlocking with ignition.

Ignition Lock Only

Enables only door locking with ignition.

Ignition Unlock Only

Enables only door unlocking with ignition.

Secure Lock Feature

Safe Start (Child Safety Mode) Configuration

Module Reset Procedure

Diagnostics - Parking Lights Flash Rate