Normal operation
Entering the disarm sequence
When you take delivery of your vehicle with the
Ghost-II installed, the professionally trained
installation team will have set a default disarm
sequence for you. This is generally simple and, for
your security, should be changed as soon as
possible after delivery.
To enter the disarm sequence follow these simple
steps:
1. Switch on your vehicle’s ignition. If the
immobilization is not starter inhibit then it may
be possible to start the engine at this step.
2. Press each button in the disarm sequence in
the correct order. Whilst getting used to the
process it is advantageous to do each press
firmly and deliberately.
3. Wait until the indication signal flashes twice
before starting your vehicle.
Should the code not be accepted after the first
attempt simply wait 5 seconds and try again.
page 5 of 20
To Next Page
