Setup / configuration
Entering disarm sequence change mode
There are 2 ways to enter disarm sequence
change mode:
1. Normal procedure:
a. Switch on your vehicle ignition.
b. Enter the current disarm sequence (DO NOT
START THE ENGINE!).
c. Press and hold the accelerator pedal to the
floor.
d. Enter the current disarm sequence again.
e. The Ghost-II will now be in learn mode, the
indication signal will flash every 3 seconds to
confirm this. You may now release the
accelerator pedal.
2. Emergency code procedure: - This is used if
the disarm sequence has been forgotten or a
button is no longer working.
a. Locate your emergency 4-digit code. This is
found on your Ghost-II card, behind the
scratch off security protection.
b. Switch on your vehicle ignition.
page
8 of 20
To Next Page
