AUX DC Inverter Free Match 50HZ R32
157
◇ If this unit is installed on a sloping ceiling, a cushion block should be installed between the
ceiling and the air outlet panel, in order to ensure that the unit is installed on a level surface.
This is as shown in the drawing as follows:
◇ Adjust the relative position of the suspension hook on the suspension bolt so that the unit can
be in level position in all directions. Check with a level gauge after installation to ensure that the
indoor unit is horizontal, otherwise it will cause water leakage, air leakage etc.
◇ Tighten the bolt and ensure that four hooks are in close contact with the nuts and washers, to
fix the indoor unit under the ceiling.
◇ After the unit is installed ensure it is secure and does not shake or sway.
◇ Ensure that the center of the indoor unit is in alignment with the center of the opening in the
ceiling.
To Next Page
Loading...
