Need help?Do you have a question about the Avago SAS 9207-8i and is the answer not in the manual?
General| Brand | Avago |
|---|---|
| Model | SAS 9207-8i |
| Category | Host Adapter |
| Language | English |
Details the PCle interface for I/O components and the LSI SAS 2308 controller chip.
Explains the SATA+SAS functionality and performance of the LSI SAS 2308 controller chip.
Describes the onboard Flash ROM for firmware and BIOS storage on the HBA.
Details the function of the Heartbeat LED (CR1) indicating HBA general activity.
Describes the PCIe connector (EC1) and SAS connectors (J5 and J6) on the HBA.
Details the dimensions (167.6mm x 64.5mm) and layout of the low-profile HBA board.
Specifies maximum power consumption: PCIe 12.0V = 1.3A, Nominal 9.8W, Worst case 16.0W.
Defines operational (0-55°C) and storage (-45-105°C) temperature and humidity ranges.
Details on securing the HBA bracket to the system chassis using screws or retention mechanisms.
Instructions for connecting SAS cables between the HBA and SAS backplane or other devices.
Final steps to replace the cover, reconnect power/network cables, and power on the system.
Updates include support information and template conversion.
Updated Section 5.5, Power Requirements.
Renamed adapter from LSI SAS 9215-8i to LSI SAS 9207-8i.
Initial release of the document.
To Next Page