• Pull enough bag material to hold the item to be vacuum packaged, plus two inches (2”). With a
pair of scissors or sharp knife, cut desired bag length from bag roll. Make sure to cut in a
straight line. Plug in power cord.
• Open lid. Place one end of cut bag onto sealing bar. Please make sure this end is not on or
inside the sealing foam ring area.
• Close lid by pressing down on both sides. Now keep pressing until the light goes off, or you can
use your left thumb to press the “SEAL” button to make an instant sealing.
• The machine is sealing the bag when the blue indicator light blinks.
• Once completed, the indicator light will turn off. Stop applying manual pressure, and press the
“RELEASE” button to open the lid. The custom sized bag is now ready for vacuum sealing.
CAUTION: Make sure you give the appliance time to cool down. Wait
at least 20 seconds between seals. Under very heavy usage, appliance
will shut off automatically to prevent overheating. If it does, wait 25
minutes to allow appliance to cool off.
To Next Page
Loading...